- solid state relay
- Circuit Board Solid State Relay
- Single phase solid state relay
- Industrial Solid State Relays
- Three-phase solid state relay
- Three-phase forward and reverse solid state relay
- Rail type three-phase solid state relay
- Industrial grade solid state relay module
- Tension controller
- Intelligent voltage regulation module
- Single and three-phase silicon controlled trigger
- heat sink
- Semiconductor module, rectifier bridge series
- time relay
- Digital display counter
- water level controller
- timer
- switching power supply
- S series switching power supply
- MS series switching power supply
- LRS series switching power supply
- D, T, Q multi-group series switching power supplies
- DR rail series switching power supply
- NDR rail series switching power supply
- MDR rail series switching power supply
- HDR rail series switching power supply
- FY rainproof series switching power supply
- FS rainproof series switching power supply
- Foot switch
- Fan water pump controller
MXCF-1
product detail
Product overview
The MXCF type single-phase thyristor trigger is designed and produced using military-grade PCB and imported microcontroller. It is used to trigger the thyristor to realize the voltage regulation function. It has a high degree of output linearization, a low output starting point, and can achieve stepless adjustment of the load voltage. , can regulate the primary side of the transformer, welding machine, temperature control, dimming, charging, excitation, electroplating, electrolysis, water treatment, etc.
Product performance parameters
The trigger waveform has good symmetry, control accuracy
The triggering power is large and can directly trigger various control signals of thyristors within 3000A, potentiometer (10K), DC1-5V, DC2-10V, DC4-20mA.
Equipped with soft-start function, the soft-start protects the thyristor and load from impact upon power-on (please specify when ordering).
The design is novel and unique, with no phase sequence restrictions, simple wiring and easy maintenance.
The main circuit and control circuit are fully isolated, safe and reliable.
Sprayed conformal paint has a transparent protective film with excellent moisture-proof, dust-proof and anti-corrosion properties.
The trigger is equipped with the function of blocking the trigger pulse due to event or fault. For example, the pulse is blocked when the equipment is turned on, so that the thyristor of the main circuit is completely shut down.
Appearance and installation dimensions/wiring diagram
troubleshooting
1. If the system indicator light does not light up, there may be no power supply or the chip is not working.
2. The system indicator light is on, but the thyristor has no output. Check whether the load is connected. If the load is not connected, there will be no output.
3. The system indicator light is on, and the output using analog signals (1-5v, 2-10v, 4-20mA) cannot be adjusted. You should confirm whether the load is connected. If there is no load, there will be no output. You can first use a 10K potentiometer to manually control and debug the load. Connect a 100W-200W bulb for testing